Sp-controls CatLinc Manual do Utilizador descarregar pdf (Página 4)

FCC COMPLIANCE

This equipment generates radio frequency energy and if not installed in

accordance with the manufacturer’s instructions may cause radio interfer-

ence.

This equipment complies with part 15, Subpart J of the FCC rules for a

Class A computing device. This equipment also complies with the Class A

limits for radio noise emission from digital apparatus set out in the Radio

Interference Regulation of the Canadian Department of Communications.

These above rules are designed to provide reasonable protection against

such interference when operating the equipment in a commercial environ-

ment. If operation of this equipment in a residential area causes radio fre-

quency interference, the user and not SP Controls, Inc., will be responsible.

Changes or modifications made to this equipment not expressly approved

by SP Controls, Inc., could void the user’s authority to operate the equip-

ment.

SP Controls, Inc. assumes no responsibility for any errors that appear in this

document. Information in this document is subject to change without notice.

CatLinc™, SmartPanel™, and the SP Controls switch logo are trademarks

of SP Controls, Inc. No part of this document may be reproduced or trans-

mitted in any form or by any means, electronic or mechanical, for any pur-

pose, without express written permission of SP Controls, Inc.

CatLinc VGA-L

The CatLinc VGA-L allows VGA (or RGBHV) connec-

tion between two or three devices using CAT5,

CAT5e, or CAT6 twisted pair cable.

Connection is made to devices using a standard

male HD-15 connector. The CatLinc VGA-L

Transmitter provides a local loop-back female VGA

cable to split the signal to a local display in addition

to the CAT5 connection to the Receiver.

NOTE: the local loop-back VGA must be terminated

or the VGA signal will be affected. If you do not have

a second device, a male VGA 75 ohm terminating

plug can be used. A terminating plug can be sepa-

rately ordered from SP Controls (part no. CatLinc TERM).

The CatLinc VGA -L Transmitter actively buffers and amplifies the source

signal, eliminating the need for the interfaces or distribution amplifiers that

are often required with VGA signals.

The CatLinc VGA -L can extend a VGA signal up to 91m/300ft over standard

CAT5 cable. At typical distances this product will provide excellent image

quality for all resolutions. It can be used for longer runs, but the image qual-

ity may be reduced. A Distance/Resolution chart (Page 4, Table 1) indicates

supported resolutions based on CAT5 cable length.

A single screwdriver adjustment at the Receiver allows fine-tuning for best

picture detail (see page 3).

CatLinc VGA-L

Figure 3 - CatLinc VGA-L Connection

1 2 3 4 5 6 7 8 9 ... 19 20

Comentários a estes Manuais

Sem comentários

Sp-controls CatLinc Manual do Utilizador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Áudio Sp-controls CatLinc